We recommend starting with the symptom: if a motor will not start, check the battery charge and connections. For a controller connection problem, check the status indicators and app messages. If a DJI camera drone will not take off, check its propellers and flight settings and look for app warnings. Power the aircraft off before checking that its propellers are attached correctly.
When the drone will not power on
- Inspect the battery connection for looseness or corrosion.
- Look for visible damage to accessible power wiring.
When the drone will not connect to its controller
On some drones, a rapid yellow status light indicates a lost remote signal. Check the status indicators and any message in the flight app, then use the instructions for your particular drone to identify what they mean.
Keep the distinction between a controller signal problem and a GPS warning clear. A GPS warning concerns the aircraft’s satellite fix, so the checks below address a different part of the system.
When the drone powers on but will not take off
Incorrectly attached propellers, a motor fault or a flight setting can prevent take-off. The camera drone take-off checks below apply to DJI camera drones and offer a structured way to narrow down the issue.
- Check the app map. With the aircraft and controller on, open the flight app and check whether the drone is in a restricted zone. Restricted zones appear in red on the DJI Fly and DJI GO 4 maps.
- Inspect the propellers. Power off the aircraft and check that the propellers are attached correctly.
- Consider the motors. Once the zone and propellers have been checked, the take-off guidance suggests checking whether the motors rotate normally. A motor that does not rotate may be faulty.
- Check Beginner mode. On applicable DJI drones, Beginner mode prevents take-off when the GPS signal is weak. You can wait for a strong signal or disable the mode using the app settings.
If the motors start but the drone still cannot take off, check that the propellers are attached correctly.
How app, firmware and GPS issues affect operation
Software and sensor warnings can point to a different cause from a mechanical fault. If a DJI camera drone cannot take off and the camera view shows no prompt, connect the phone or screen controller to the internet, then update the aircraft firmware and flight app.
A lost GPS signal means the drone has failed to lock onto enough satellites. Buildings or trees, nearby interference, outdated firmware and compass or IMU calibration can all be involved. You can also inspect the GPS module for damage.
For a GPS warning, we recommend moving to an open area, rebooting the aircraft, checking for software updates and following the calibration procedure for the compass and IMU. A stable GPS fix supports position hold and Return-to-Home, so resolve the warning before relying on those functions.
When to stop and seek repair
A visible fault does not necessarily explain every problem: in one repair example, a loose motor wire was a problem, but reconnecting it did not repair the drone.
Note the symptom and any app message before arranging a repair.
Leave a comment